I set the altitude before flying in the flight plan to 16,000 feet. Immediately after I took off, the controller asked me to reach and hold 16,000 feet. However, right after being transferred to the Milan Center, I was asked to go to FL260 (?). Then I thought … ok, I want to go back from 26,000 to 16,000 (my initial flight plan), so chose the option (from ATC) to decrease my altitude by 10,000. However, after I selected -10,000 from the menu, the voice asked to decrease it to 6,000 (which was not my initial intention). I was denied … probably because it was too low to fly over Alps (or for another reason). However, I don’t see an option to get my altitide back to my flight plan … and as I flew the Cessna I would eventually be drop from ILS … because I wasn’t able to reach that altitude … this seems broken.
As for the stick… I think it may by the cable port thing of my X52 Pro… The port is kind of loose (bad desing in my opinion) and it may lose the conection. The aircraft is banked to the side by like 30 degrees when AP is enebled to compansete for the side leaning… The only soltuion I found so far is restart the flight.