Hello
I am currently flying the Aerostar 600 and my Heading Indicator is way out of sync with both the compass and the GPS 750…
Also - when I dial in a HDG it will ofc be different on the GPS and the Heading Indicator - it’s off by about 90 degrees…
The DG-Slave-Switch does nothing…
How can I adjust the Heading Iindicator so that it shows the correct heading again?
Thanks guys/gals!
Michel
if i understand your question correctly, have your tried pressing the letter “D”
Yes - thanks for asking. Yes I hit “D” as well
It has a long sync process, so you’re not going to see an instant result with it.
Next time C&D, turn it on early and observe the sync slowly happening.
Can I do this in-flight? Or only Cold & Dark?
It does sync very slowly compared to other models of HSI, but it is realistic behavior for this model.
However, as I was informed by someone from A2A: put the mouse over the HDG select knob, hold down the left mouse button and click the right mouse button. This will push in the knob so you can manually slew it, saving lots of time.
Nice! Thanks! Also - I just tested - it works also in flight - it takes time but it works
Thanks all!
Yeah, I was doing an IFR departure while on VATSIM and I told tower I needed to wait for it to slew - and the avionics had already been on throughout the startup sequence, taxi, and runup. Definitely not departing on vectors while that’s still syncing. It ended up taking 8 or so additional minutes.
Posted it here and got the answer regarding pressing both mouse buttons. Big time-saver.
Yes. I’d just suggested the C&D, so you could see it aligning while sitting still. Sometimes these things are harder to observe with the aircraft in flight!
Glad you found it working.