Same for me. Not going back to DX11.
Please the fix the com3 124.850 bug which automatically tunes to salinas atis loop. Turning off com3 doesn’t fix it. You can even turn off com2 and no fix . And u can even change the freq and no fix . Please fix this thank u
I spent some time searching the forums, but no solution found.
How do I map the thrust reversers with the Honeycomb Bravo? As it does not have detents, I cannot map everything from TOGA to reverse on the same thrust axis. Lowest setting is Idle then. I tried to use the area below the axis which is a mappable button, but did not found an input accepted by the Fenix to engage reverse thrust.
As a sidenote I also started to have the issue where the A320 does not accept any inputs during a flight, no matter if buttons, sidestick or mouse input. Aircraft is uncontrollable then. Is there a fix on the way?
Many thanks.
You could perhaps map all of the virtual detents onto your throttle axes, despite the lack of physical detents, as the sound the virtual levers make when they hit a detent can be a reasonably good substitute for an actual detent.
As for the loss of control, that sounds like the MSFS window might be losing the windows focus. To prove or otherwise, the next time it happens, just alt tab back to MSFS and see if the controls work again. If this gets them working, the next job would be to figure out why it is losing focus in the first place.
This is a good guide for mapping Honeycomb Bravo:-
1 Like
Also received frozen displays today.
For me, since the last update, i experience loss of heading in nav mode.
Normally it was autopilot on and follow the waypoints and some work in between could be done.
Now every ones in a while managed heading disconnects and if i don’t watch it it can go completely off course
Hello Guys
For everybody with Display Freeze I found out it happens usually with using GSX Pro and restarting GSX while being in the sim! Could somebody confirm this?
i dont use gsx and my displays freeze constantly
And I use GSX and my displays never freeze.
1 Like
For me it freezes at DX11 and DX12 
Switch from cpu to gpu display rendering , helped me. Now displays work again
Finally the new reflective surfaces for the throttle lever and the trimwheel is finished!
I hated how the throttles looked like having a thick layer of wet transparent slime on them 
now this is fixed.
The screws for the throttle quadrant are now better looking with a hint of discoloration to make them stand out a little bit as interesting detail, and the throttle quadrant is now in 4k resolution. 4096x4094 enhanced by bicubic smoothing and sharpening, like any good texture should be in the year 2022!
It´s magnificent and exactly looking as in the YouTube Airbus videos! I can almost feel the smooth cold expensive material the trim wheel and throttles are made of!
Upload tonight with the newest version of the Fenix cockpit overhaul…
2 Likes
Ok i will try later, this happens to me after the latest update, i never had before, i always use CPU rendering
1 Like
With pushback by GSX the Fenix freezes instant, try out yourself!
Does ambitious toolbar pushback works now with Fenix?
I use the GSX pushback with Fenix normally without any problems.
Are you using DX11 or DX12? Are you in SU10 or SU11?
DX12 and SU10.
Then it’s obviously an SU11 problem. Anyone found solution to fix it in SU11 beta?