Good evening, I’m writing to you because I’m having two problems with the A320. The first is that, after entering the data into the on-board computer on the ecam, and when I start the engines, I get the message “FUEL ZFW ZFWCG DISAGREE.” The other problem is that having set a flex, and therefore a maximum engine power value for takeoff, on the ecam the message “No Thrust setting” is displayed. Does anyone know what the problem might be? Has this happened to you? I play on Xbox Series X with the default aircraft. Thanks everyone
Hi @ELECTRICDP92 ,
Thank you for this report. We’ve moved your topic into the User Support Hub.
The Bug Reporting Hub is for posting suspected or confirmed bugs that other users are able to reproduce without duplicating an existing bug report. Using the template or providing all the relevant information about your bug and sim setup is required in order to provide valuable information, feedback, and replication steps to our test team.
If you are not sure if your issue is a bug or need further input from the community, please use the User Support Hub category. If the community can replicate your issue, first search the Bug category to see if there’s an existing topic. If it already exists, contribute to that report. Duplicate bug reports will be closed.
If you believe it is a new report and no duplicate exists, then create a new bug topic using the provided topic template.
All issues caused by or involving third-party addons/mods should be reported to the third-party developer. Assure that no addons/mods are used when reporting issues in Bug Reports.
And where i can see the answers ?
Here in your topic you’ll see users answers.
1 Like
Sounds like the MCDU programming is incomplete. Please show screenshots of all MCDU pages you have programmed.
Hi, I don’t have a screenshot at the moment but I assure you that I have entered the weights, block fuel, zfw and zfwcg but when I proceed with the automatic ignition of the engines I get that message
Could it be that the correct ignition procedure is not being followed?
The question is: are the values correct and matching the configuration of the plane?
Well, I take the weights from the plane’s tablet, the passengers from the game’s tablet, and I take the fuel from the fuel management screen, basically the screen before the pilot arrives in front of the plane… I’ll start by saying I play on Xbox…
Loading a flightplan and the loadsheet to the EFB does not necessarily mean you have loaded the plane correspondingly. In particular in the MSFS2024, where are two EFB which can load the plane.
So how do you advise me to proceed?
Do you use Simbrief? Please show your Flightplan, Loadsheet and
no, I fly in career so I use the flight plan of the game tablet… and the loadsheet is the one I have in the airplane tablet where by setting the peei it gives me the loadsheet
Go into the MCDU and select the fuel page. Then hold down the third button from the bottom on the right to sync the fuel values from the EFB and plane to the MCDU.
Also, check that the ZFW in the MCDU is the same as that in the simbrief plan and the A320’s tablet.
I had the same message last night and that was my issue.
I think I understood the problem. .. . I had this last doubt I think I understood the problem. .. . I had this last doubt and therefore one last test to do… .. I realized that the problem is the ignition of the engines, that if done automatically by the game is as if the values were reset in the plane and therefore does not recognize the data entered. This morning I tried to make a flight and I started the engines with the actual procedure, so I switched on the ignition and then, one by one, I started the engines and, as if by magic, on the “Ecam didn’t come out of any alarms”
1 Like