I have this MCP MCP Module Ethernet, but i don’t know how use with MSFS…is there any app or driver for use in MSFS with PMDG 737NG?
Spad.Next is probably your best bet. Allows you to set up external modules to control bits and pieces of your plane, in this case the MCP panel
For a $1000 module, another 30 (adjusted for USD from British Pounds) to get it working shouldn’t be too much an issue.
You may be spending some time getting the mapping right if you can’t find a ready-made profile.
Side note, I’d drop $1000 on one of these…
I have Spad.Next…in support they said me that is not possible connect to this MCP because there is no published SDK
fair enough. Just poking around a little i thought there might be a driver or something with it but you might be out of luck. I think this stuff is mostly marketed towards DIYers and commercial ventures. that iFly 737 software is nearly $600 so the people they’re selling this stuff to are the 1% of the 1% of flight simmers
Did you contact Sismo support to see what they said?
Sismo Soluciones said that they have a driver project since 2020 for MSFS called SimLink; the said that driver will be release about second half 2021…and after 2 years …nothing else…no news.
Ah yes i see the blog post too.
Maybe try reaching directly through email: Contact us
Other than that, you might be out of luck