I select the option checked the Send to FS as normal axis and then selected the same control bindings I use as without FSUIP. I cannot remember which one it is off hand an Im not around my sim. I set throttle 1, throttle 2, and Condition 1 and 2 (using the propeller axis in FS) Everything is a complete copy. The problem that I have is that with the throttles, I cannot get them to calibrate so that when my levers are at idle, the throttle in game drops down to Ground Idle. Lowest I can go is the top of the green arc, which i thing is full manual throttle just below the notch detent. The other issue is that condition lever 1 will go to the fuel on detent but anytime I try to cut fuel, it pops back up into the fuel on state and restarts the engine. Condition lever 2 just pops back up to auto no mater what positon the lever is in. I have always assumed that I am doing something wrong and that this isnt a bug in game.