C-208 Caravan Start-up issue!

User Support Hub Aircraft & Systems
,
1

Hello guys ,

I am trying to do a flight , using the C-208 Caravan , but i am unable to start the engines !
If i choose a free flight , then the aircraft , is lined up on the runway and the engines are shutting down !
I tried to start them , but nothing happens !

Any idea what is goin on ?
All the rest of the Msfs2024 aircraft are working without this issue !

2

Hi @TeemingChief ,

Thank you for your post! Your topic has been moved to a sub-category of the User Support Hub

The General Discussion category is meant for discussions that fall outside of our other sub-categories.

If you would like other users to help you with an issue you are experiencing in the sim, consider these User Support Hub categories for your future post:

Aircraft & Systems
ATC, Traffic & NAVAIDs
Crashes (CTDs)
Hardware & Peripherals
Install, Performance & Graphics
Scenery & Airports
User Interface & Activities
Virtual Reality (VR)
Weather & Live Weather
Miscellaneous

3

What is the state of the fuel shutoff valves and condition lever.

4

Some screenshots of the cockpit would help here, so we can see position of switches and levers (also the overhead knobs) - make sure you hide the yoke if you do take a screenshot.

But, before all that, check that your levers are all in the correct position

  • Red one on the right should be full forward if you’re on the runway for takeoff
  • Blue one in the middle should also be full forward
  • Black one should be around the Idle mark or at the top of the Beta range
  • Overhead fuel cutoff knobs should both be ON
5

Here you go ,

Untitled 1
Untitled 11920Ă—804 157 KB

Untitled 2
Untitled 21920Ă—804 133 KB

Untitled 3
Untitled 31920Ă—804 93 KB

Untitled
Untitled1920Ă—804 154 KB

I think the issue is the Engine Condition ( Cut Off ) !

Whatever i do , it always goes to cut off pstn !

6

Check your bindings.

2 Likes
7

I just did !

Something is in conflict with mixture control !
Not found yet !

8

Try searching “mixture”?

1 Like
9

Found and solve the issue !
You were right , it was bind in my Throttle , and i did not know that !
Everything is ok now

Thank you very much !

2 Likes