I’m kinda of bumping this and requesting this to be somehow logged, or if someone could please explain why it’s not. The EFB errors are very obvious, and can be completely replicated.
In free flight mode, let’s try to load the SkyCourier:
Configure the aircraft and just move the seats slider to full:
So, the first section, which has apparently six passengers, can weight up to almost 16000lbs, which gives a weight of 2600lbs per passenger approximately, and this happens on each section of the fuselage.
I don’t see anything about this tackled, and I don’t understand how this isn’t in the scope apparently, since it renders a simple operation like loading the aicraft and calculating basic things like mass, CG and trim, impossible.
We have created an internal ticket to see if our team already has this logged, and if not they will attempt to reproduce the issue and create a new bug report. This item is now marked as feedback-logged. If there is an existing bug report or one is created, we will move this thread to bug-logged
Do you have the same issue if you follow the OP’s steps to reproduce it?
• Yes
Provide extra information to complete the original description of the issue:
• Same behavior in Longitude. It works if you only do passengers and fuel. Cargo “breaks” it, cannot be set to anything other than 0.
If relevant, provide additional screenshots/video:
•
Do you have the same issue if you follow the OP’s steps to reproduce it?
• Yes
Provide extra information to complete the original description of the issue:
• I have the same issue in both employee and freelance missions, I can only change my fuel if I go back and manage my aircraft. I have no choice during employee DHC-2 missions but to use the refuel and repair cheat because they don’t give me enough fuel and I can’t add more in the EFB.
Do you have the same issue if you follow the OP’s steps to reproduce it?
•
Yes
Provide extra information to complete the original description of the issue:
•
The workaround by @RedBanana94 works. If I set the cargo slider to 0 and move the passenger weight, I can load weight.
Also, the weight on the passenger screen is incorrect. It shows a much reduced lbs amount. The weight itself is correctly loaded if you use the percentage as a reference, though.
If relevant, provide additional screenshots/video:
•
Yes, setting cargo to zero (or even better, do not touch cargo at all) worked for me. I did notice however atleast with the vision jet, if I only change passenger weight (leaving pilot weight as is) it will not register, however, if at the same time you make change to pilot weight, changes to passenger weight will also go through. It feels like the game only checks if pilot weight has changed and then update all seats only if pilot weight has changed…
Edit: I noticed ZFW is 3650 and MAX ZFW is 4249, this leaves room for 3 people at 200lbs each as maximum… seems odd. This is probly why if you try like 50% seat quick fill it fails (only filling the pilot seat with weight). Anyhow, the more I try different combinations, the more I am scratching my head…
Edit 2: I give up, the above may or may not be correct
Do you have the same issue if you follow the OP’s steps to reproduce it?
• Yes
Provide extra information to complete the original description of the issue:
• Unable to properly load passengers in the Vision Jet. When I attempt to add a co-pilot or rear-most passenger, the load fails every time.
If relevant, provide additional screenshots/video:
•
