Hi Guys ,
when flying at low altitude I get this horrendous ground elevation change , after which the tress and buildings remain at the original height ad the ground is a few metres below , ive attached a screenshot .
anyone else have this same issue ? , ive messed with every slider on LOD etc , but no difference.
Same for Low Quality vs Ultra
Hello,
Welcome to the forums!
We ask that people not use General Discussion for help, advice, or troubleshooting. I have moved your post to World , where you can discuss issues with scenery.
For future reference, here is what a few of these blue categories are for:
- Aircraft
is where you discuss current or future planes coming to MSFS as well as assistance with liveries. - World
is where you discuss scenery, airports, and weather. - Aviate, Navigate, Communicate
is where you ask for help with flying. - Tech Talk
is where you discuss installation, graphics, drivers, performance, CTDs, and hardware. - Menus & Activities
is where you discuss activities (landing challenges, bush trips, etc), plus anything accessed through the menus including the Marketplace, settings, logbook, cameras, etc.
Yeah I’ve noticed similar in a few places. Seems very location specific. Where is that?
New Zealand a place called Lake Tekapo
a non Photogrametry area , I had a thought it may not be present with photogrametry areas so will test .
Sure does ruin the immersion.
Ok so it seems I have found the answer.
ORBX Released a Mesh Update a while ago for New Zealand (which I thought was in community folder)
but it was actually installed in content manager.
Since the New Zealand Update from Asobo it seems the two Meshes were fighting each other.
after Removing ORBX Mesh, all is well again …happy Joy
1 Like
Good one. I still have the problem but can’t remember where I saw it last until I check the screenshots I took