Ground vehicle's on runway and taxi way's

Discussion Hub General Discussion
1

I generally fly out of KCRQ in Carlsbad, CA. I have the “Airport Vehicle
Density” set to 50. At this setting I find the ground traffic on the airport is very dense, but most important is the fact the vehicle’s are all over the taxi way’s and even on the runway during taxi, take off and landing.

I like the idea of having a natural number of vehicles in the sim, but not on the runway and taxi ways too much. I am playing with the density number and hope a lower number will clear this up. Just wondered if anyone else ran in to this issue on this or any other airports.

1 Like
2

Yes, and I only have density set to about 20.
ATC cleared me for take off yesterday from Londonderry and as I turned on to the active a fuel truck was driving down the centerline lol. Had to wait a minute while he vacated.

3

I also notice that they’re stopped in the middle of a taxiway too. I have to move around them, sometimes onto the grassy area. Sheez.

4

Yep, very distracting. The AI has no clue about the #1 rule on ramps - aeroplanes ALWAYS have priority. They just drive around aimlessly which ruins the effect.

5

Be patient, lots of new workers just practising the correct manouvers at airports. Yes, I know they should practise some where else.

-eelis-

1 Like
6

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.