I’m not sure how to proceed now with my issue. Everything worked fine last time I used the Alpha on April 14th, tried today and Y axis is a mess.
Using Windows calibration tool, and raw data display, I can see that full range is not utilized, and when the yoke is fully pulled in, the value isn’t stationary but jump up and down.
X axis works fine. All buttons work fine. Y axis is screwed for unknown reason.
The Alpha was purchased on January 19, 2023 so it is slightly over a year old and still within 2-year warranty, but Honeycomb has it discontinued so no hope for replacement, I think?
So far, it looks like I will be forced to unscrew it and look inside, at least clean the potentimeters and check the wires/soldering.