Is there a way to make the movement of the yoke mirror the yoke in the sim exactly ?
When I turn the yoke approximately 45 degrees in either direction the yoke in the sim turned 90 degrees also when I pull back on the yoke at about mid point of full travel the yoke in the sim snaps fully forward and then as I keep pulling back the yoke shows correctly again. I just noticed that recently. I fiddled with all kinds of adjustments but couldn’t make it work. On the sensitivity graph the Alpha yoke checks good and doesn’t show any snapping forward as I pull back.
Have you calibrated the yoke in windows?
Yes but i will try again
Which aircraft? For me the Milviz C310r doesn’t match in vr
Also, check the calibration in MSFS. If the calibration is not linear the controls will not follow the yoke but will follow the calibration curve.
1 Like
All of them