Hello All, as I was checking out the A330 through the walk around and also used the drone camera to take a look at the 3D model and to check out the details of the plane. I did noticed something that needs a small correction. The horizontal stabilizers needs more angle as it’s too flat compared to the real A330 as you can see here, It’s just needs a bit more angle. I have tried to make the comparison as close as possible. I wanted to provide this feed back because I like everyone else wants the A330 to be as realistic as possible. The small details matter also. Really hope it gets corrected. This is more about the 3D art of the plane, nothing more.
ISSUE DESCRIPTION
Description of the issue: Horizontal stabilizers is flat compared to the real A330 as you can see here
REPRODUCTION STEPS
Please list clear steps you took in order to help our test team reproduce the same issue:
- Allow inibuilds to make the corrections
MEDIA
https://www.jetphotos.com/photo/10733154
Note the trim during landing being at the upper end of the green trim range
This picture not only demonstrates the different geometry, but also the significant trim setting during landing
https://www.planespotters.net/photo/1406698/d-aikr-lufthansa-airbus-a330-343
The A333 trim is close to 4 units UP during landing which I think is the value it resets to after landing. This video shows that the trim takes quite some time to reset after landing, showing that the real aircraft lands with more pitch up trim. Time stamp at 12:52
Airbus A330-300 landing Seattle Tacoma SEA runway 34R - cockpit view 4K - Mount Rainier
https://www.jetphotos.com/photo/11683047
This perspective also shows the significantly different trim setting during rollout
https://www.jetphotos.com/photo/11691283?utm_campaign=iOS&utm_medium=Referral&utm_source=iOS+App
This clearly shows a different trim setting than the one you’d see in the MS/ini A330
