No terminal buildings now, just jetways hanging in the air. To make it worse, the Seminole avionics won’t turn on with my saitek switches.
To begin with, today’s update was an AIRAC cycle update. Has nothing to do with your graphics or controls for an add-on aircraft.
Something else changed. I would suggest checking your data settings, deleting your cache file etc.
2 Likes
There was a list of changes when i down loaded the update, not just AIRAC. But I will delete cashe, and also turn off PG and see if there are any terminal buildings at the airport.
That was from last week’s patch - they didn’t update the notes, which obviously is causing confusion.
Today’s update was on 1gb and it fixes the autopilot bug for the A320 and maybe a few other small things.
OK I didn’t understand that…not very clear for us old folks! I cleared cashe, unchecked PG and Bing, and tried KSFB again. No buildings, just jetways. Anyone want to check this on their system??
in the middle of a flight currently, but will check it out after I land!
I flew for 2 hours today with the Seminole, after the update was deployed. It worked as I expected with my Logitech switch panel.
It might be worth running the panel tester software to ensure it is working properly. If you don’t have that installed already, you can get it from Logitech.
I’ve had very rare occasions where one of my panels has stopped working properly, and each time it has been the multi panel. You can tell it has gone wrong as the pane is lit from the side only, but it shows no characters. Usually I then run SPAD with admin rights to fix the issue of having enhanced power management turned on. Logitech panels hate that!
The original site that hosted this has gone down by the looks of it, but I managed to get hold of a copy.
https://forums.x-plane.org/applications/core/interface/file/attachment.php?id=259353
In case that one goes I uploaded it to my OneDrive as well: