Motor keeps cutting out

Discussion Hub General Discussion
1

Hi guys, just wondering if anyone else has had issue with motor stopping when going to outside views and back to cockpit view, or going to control panel to adjust controls etc. most frustrating.

2

Are you finding that your mixture might be getting reset? Did you change the binding for going to an outside camera view, and perhaps you have a double binding? It does happen, even though the interface tells you there is a conflict.

3

It started after the previous update. I have checked all bindings cant find a double binding .

4

I have just found the issues .The mixture control is moving in and out by it self. I have no control over it .I have unbound my control checked all bindings and there is no double binding so Im at loss why this is happening

5

Do you have auto mixture enabled ?

1 Like
6

It was off . tried it on and off and it still keeps moving back and forth by it self.

7

Empty or renamed community folder? (automixture doesn’t actually move the mixture lever)

1 Like
8

Community folder full and not renamed.

9

Suggest to rename or empty it for troubleshooting.

1 Like
10

Will try it thanks.

11

I too have experienced this in the last two weeks…

1 Like
12

Do you have any drivers for external devices like FUICP installed ?

1 Like
13

No FUICP installed etc

14

Is this problem in every aircraft or just some ?

Does it do this on the ground ? If so start up a plane on the runway and once the problem occurs unplug all your USB devices including mouse and keyboard and see if the issue goes away.

15

Happens on ground and in the air.

16

I have just found a mixture axis linked to my mouse. I think this is the cause of the problem. Thank you all for your help. Very much appreciated guys. cheer Mike

1 Like
17

and you said you checked all bindings?
ah well another user error solved.

1 Like
18

Checked all the controllers except mouse. I have never added anything to mouse, so must have changed when update happened.

19

I’ve had this happen with my throttle setting being bound to a mouse axis, when I never change my mouse settings. Very strange stuff.

1 Like
20

I shall check my mouse bindings immediately. I’ve had this issue flying the Islander (I haven’t tried with other aircraft yet) since the last update and something dodgy going on with the AP too. The engine cuts out unless I have about 10% throttle. It was OK before the last patch. I’ll check mouse bindings now just in case the patch added something there.