Got a point there. Hold on. So I used to set up my cockpit views normally using the cockpit tab of the camera utility. For my wingviews (and other external views attached to the airplane) I also used the cockpit view. Back in MSFS 2020 this was possible by moving your primary cockpit cam far left or right, then heading into the cameras.cfg of the respective airplane and changing the XYZ position to an x value further left (or right respectively), reloading the sim and you were outside the cockpit so you could move towards the wing for example and set up your view there using custom camera keybinds under the cockpit cam section. Worked perfectly fine. Now with the streamed content, I can´t find the cameras.cfg for airplanes, so I tried to figure out a way to set up wind views without editing a cameras.cfg file which was actually possible by moving far right in the cockpit while captain´s position is activated, thereafter opening the cameras menu and selecting copilot there which got you through the cockpit window. YOu could then move towards the wing just like you would move around in the cockpit.
However, some short time after setting up the last perspective, my sim crashed to desktop and since then, whenever I try to load the ini A330-300RR (which was the one I set up the perspectives with), my sim crashes to desktop. After one crash, whenever I restart the sim it will instantly crash even before being able to choose an airplane. I´d like to test whether other airplanes will still work, and whether the whole inibuilds lineup suffers from it or not, or even the whole lineup of airplanes. In the meantime, that´s a possibility to set up your cameras but be aware that this may be bugged and mess up your airplanes. I´ll report back in a few minutes hopefully.