Okay everyone I really need some help. I have googled, searched forums, read through and asked on a MSFS discord, and I don’t know what I have done but I can’t seem to get it fixed. I hooked up the 5 monitor and got that sorted and Now when I start MSFS the 3 windows that normally render only do so in 2 screens. One on the right and the other two windows on the same middle screen. I get it all fixed and load into a flight and after the loading screen it does it again. I get it all fixed fly around and the exit back to the menu and after the loading screen it does it again. I cannot seem to figure out how to make it stop and have each window save on its respective screen!!! I’m about to throw something.
So you need a left view? It could be as simple as changing the parameters on one of the center view monitors (the one physically on the left) so the lateral displacement is -90 or +90, but you’ve probably done that?
yeah i have to go in to the experimental tab and make the two sides “windowed” as soon as i do that both windows instantly go to the correct screen with the correct numbers that were previously set up. i then make each window full screen again and everything is good to go. but as soon as i load into the main menu it starts again
Make sure you setup the monitors in Windows before going into the Sim. Once in the Sim go to the Experimental tab and delete any windows you see there. Then create two windows one at -90 and one at +90 - Save those settings and see.?
You said five monitors…how are you using the other two?
i use 3 screens as the cockpit and the other two below the three are for air manager
What happens if you skip loading Air Manager into the two monitors and, instead, pop out and move the MSFS map onto one of the monitors and, say, pop out and move the ATC dialog window to the other? This is to make sure the issue is not a conflict with Air Manager.
so just an update. i have no idea what i did to fix it, but whatever it was it was within the experimental tab. i just started changing settings and something i did finally works and it’s working seamlessly now. just wish i knew what the issue was for the future
1 Like
Oh well… glad its fixed!