New Honeycomb Alpha. Recognized in Windows but not in MFS

Hey all, I just received a Honeycomb Alpha and man does it look nice. But that’s all I can do with it right now. I can see the device in Windows, and in its properties, Windows can see all the active yoke and button inputs. But MFS acts like it’s not there at all. When I go to Options > Controls, it’s not shown. Yoke doesn’t control anything in game.

Apparently no drivers are needed (Honeycomb Downloads – Honeycomb Aeronautical).

Am I missing a setting or additional MFS package? Not sure how to proceed.

I’m sure people with more experience than me will chime in, but try and disconnect the USB cable from the PC end and re-connect it after a few seconds, while MSFS is running. Good luck.

Tried that - no response from MSFS. Thank you though.

Solution was here, under Disable Steam Input.

https://flightsimulator.zendesk.com/hc/en-us/articles/360016005980-Peripheral-Troubleshooting-on-Steam

I’ve had mine for a few weeks now and all I did was start computer, allow it a min to boot,then plugged the yoke in the USB port…it beeped. I then restarted my computer, started MSFS,and it was there under controls in the sim. Just my experience…