My plane, no matter which one I pick, will not rotate off of the runway. Full elevator, and nothing!! Anyone else? Xplane is looking great again!
1 Like
Flight model set to MODERN?
Not sure what is going on for you but all my GA planes are working well
I’m downloading the entire game again right now. We will see what happens.
Re-downloading will most likely not solve the problem…
1 Like
Than what will? Worked great yesterday! Updated this morning, now ■■■■!!
probably need to set joystick sensitivities and adjustments since that is an item that has been updated in this release.
1 Like
Viewing the takeoff from the outside, the elevator is in the full up position.
Again, flight model set to MODERN?
At full deflection, sensitivity and/or deadzone settings don’t make any difference.
Do you mean elevator?
yes elevator.
The game was also showing my framerate on the side, with dev mode off!
I had to reset the calibration of my yoke after Update #5. The sensitivity of the yoke had flattened dramatically to the point where most of the movement was in a dead zone and then went completely off the graph only at full deflection.
This can happen if you enable e.g. the framerate display and disable dev mode while the display is still active.
I have found that my controller sesnitivity curves have been totally overwritten in the new update causing my joystic to be barely responsive. please check your controller sensitivity curves.
1 Like
Change your flight model from legacy to modern in settings and report back.
I finished redownloading it. And now only 2 planes show up.
Redownload them from the content manager.
1 Like
Thank you. Never had to do that before.
1 Like