I have been wanting an easy way to add custom interchangeable labels to my Honeycomb Bravo throttle for the switches and came up with this solution after looking at some 3D printed options on Etsy yesterday. I created a template in AutoCAD to make the labels, printed them on standard printer paper, and “laminated” them using packing tape. The label holder is made from a piece of plastic sheet from a RAM stick blister pack, folded over and pressed flat with a heating iron. Then it was stuck to the throttle with some heavy duty double-sided tape. Near zero cost solution and I can make as many labels as needed. I have done three so far as I slowly work my way through building Spad.next profiles for the 2024 aircraft.
11 Likes