The strange thing about that is if you do it this way:
- Install the navigraph using the installer.
- Start flying, all the navdata is updated they look good.
- Copy the navigraph-navdata folder from the community folder to outside.
- Then use the navigraph installer to remove the installation.
- Copy back the backed up navigraph-navdata folder into the community folder.
- Start flying.
When I do that, even though I can see the updated navdata as if it was installed using the installer before on the world map, but when I start flying I tend to see some weird things that’s different. Like the ILS identifier is not appearing properly, and some approaches doesn’t match the charts. And this is testing on the same airport on the same approach.
But when I manually delete the backed up folder, and use the installer again to install the navigraph mod. When I start flying the same approach, everything looks good. The ILS identifier is properly shown, the approach matches the charts, things like that.
So using that observation, while the bulk of the mod does come into the community mod. I feel like there’s something else that the installer does to “properly” make the navigraph usable. And just placing or removing the navigraph mod folder without using the installer, it creates some weird issues with and without the mod.