Saitek Yoke Elevator Axis Not Working

Everything works fine on the preset for Saitek yoke, except the elevator axis is binary rather than being an axis. It’s either neutral or deflected fully.

The yoke is set up fine in Windows- it registers all the axes correctly. It works fine in X-Plane as well. Adjusting sensitivity settings does nothing, because the software seems to think there are only three elevator positions (UP, NEUTRAL, and DOWN).

1 Like

Hey, did you fix the problem? I have exactly the same issue, even installed X-Plane as you did, just to check.

Hi forMS6752
Have you assigned you flight controls to an axis??

eg, Elevator - Elevator Axis (not Elevator Up or Down)

Yes, it definitely is recognized as an axis, even ubound keyboard controls just to be sure.