Dear all,
I love the plugin Flighttracker for the Streamdeck, but have a short question.
How can I enter a frequency with 3 digitis after the point ? The numpad stops after the second one.
example: 118.235
Cheers
Jörg
Which Streamdeck do you use? In the documentation of the plugin it says “This does not work on the Stream Deck Mini due to the limited number of buttons.”
Maybe that might be in your case?
Sorry,
I’m using a Streamdeck XL
I’d have to try, but shouldn’t it be sufficient to enter 118.23?
I flew yesterday EKCH > EKRN, using the default ATC.
Some frequencies didn’t work via using the Streamdeck Numpad, only by using the KI.
I’ll check later, wich frequency it was.
Solved: my fault
Maybe add some info for people to benefit from your learnings? Thats how forums work.
2 Likes
Agreed!
Even if the problem was caused by something you were doing wrong, you should still post the resolution. If you made that mistake, chances are someone else will.
It was my fault. I tried to enter the complete frequency. I should stop after the two digits behind the dot.
Cheers
Jörg
Sorry, back again. Here is now a valid example.
At EDDW I should tune to 121.755 after entering 121.75 it shows 121.750.
How can I enter .755?
Cheers Jörg