TCA Quad Wont Start Engines even in Default

My TCA Quad even in default will not start engines. They try to start but go only to N1 - 1.0 and stop at that point and will not fire up. I can push either engine 2 first or on first and same thing. They just will not go past N1 - 1.0. Any help…

Two rather obvious questions.
You do have fuel onboard?
…and is the APU started with Bleed turned on?

Didn’t you have a duplicate post about this somewhere? If you have some recording to share from when you start the flight session, it would be helpful.