I have two Saitek throttle quadrants (both USB). I recently moved to a new computer. On the old computer they worked fine and I was able to program the buttons via MSFS controls menu. No issues.
On the new computer, the buttons were set to the way I had them programmed in the old computer; so MSFS must read from the cloud.
I can still program them and they work fine; until I close MSFS and restart, then that programming reverts back.
Anyone have any idea and what I need to do?
Thanks.
I have 2 saiteks as well …was an issue initially to set them up as two independent units.
Been a while since I have done it (in 2020) but I seem to recall as long as they were both named differently (Quad 1 or Quad 2 etc) when setting up the controls I had no problems.
I tried that and MSFS just changed the names back. However, I just tried it again and it seemed to retain the new names and resolve the issue. I probably should have re-tried it before posting.
So I think I have it resolved, but I don’t trust it. So we’ll see if it stays fixed.
Thanks for the quick response.