I recently picked these up to make a throttle for my Cessna… Amazon.com
When I load up the windows calibration the travel from 0 to 100 is nice and smooth. however when I go into the flight sim, I only have to move the slider Pot about 20mm and it goes to full throttle… I have played with the sensitivity settings in the Sim but it doesn’t allow FULL travel of the Linear pot in sync with the sim throttle. regardless what I do it seems to go from 0 to 100 in less than an inch… Would it be the OHM of the Linear Pot that needs to be increased to allow full travel? Forgot to mention, I have it connected to a Leo Bodnar Board
All good, I resolved my problem by connecting it to the Arduino Uno and used a preset in Mobiflight…