Hi all,
Due to a recent problem that occured after the updates were done that wiped out my traing records/results, done the latest update this week and again all training modules were set to 0%.
I’ve been working my way through them again, ok format has changed from when first installed but the pattern and landing module maybe has a problem, it’s supposed to start at 80 knts and 6000ft but for me it’s at 5000ft and around 60 knts, so I power up and climb to 6000ft and hold on 80 knts, I get the green ok for the 80knts but the 6000ft never changes to green although needle is sat right on 6000ft and I’m just short of the 8000 points for a good session.
Has anybody else seen same problem in this landing module?
Edit: Anybody? Any comments even if you don’t see this problem.
regards
Steve