I just tested my Flightstick with two other aircraft to confirm it works right, and it did. Only the Transall pulls extremely to the right. So extreme that I will finish flying a circle with less than a minute. Both props are at the same level/power. Wind is at 9 to 11 (round about).
Any idea what went wrong? I tested the Transall another three times, and it always pulls massive to the right. Sometimes it takes some minutes until it starts, but in the end it always pulls to the right. To prevent me from doing a mistake, I also tested direct ready from rwy, but that made no difference.
Torque ? do both props rotate in same direction if so it’s probbaly torque use trim to null it
I tried Autotrim with no effect. How can use trim manually to stop the Transall from tilting to the right? And why it is always the right direction no matter where i start?
no auto trim wont help you need to use rudder or aileron trim
if engines both rotating same way it will provide huge torque which will cause plane to bank in that direction
I now tested to deactivate “Auto Rudder” and it stopped pulling to the right. Now it pulls to the left, but not as strong as before to the right. And it could be the wind now since the aircraft did not tend to tilt anymore.
Can I make props rotate into different directions then? I did not realize that problem with ATR 72, BN Trislander, DH Caribou, DC-3 etc. What is the difference with the Transall?
Props all rotate, single prop aircraft will all have torque pulling them one way on a twin engine plane if the props rotate in the same direction you get double the torque if they rotate in different directions to each other (Counter rotating props) then this effectively cancels out the torque so its aircraft specific .Usually rudder trim or aeirlon trim is used to cancel this out (usually rudder) it sounds like auto rudder was trying to auto compensate
Yes probably. Auto Rudder cause very often trouble. e.g. with PMDG 737 while taxi AFTER landing. Before start it is usually no problem.