Airbus H135 v0.75 is now up on Flightsim.to! Leave us a 5 star review 
- FADEC now controls engine RPM and the user’s throttle controls collective, it’s now unnecessary to bind a propeller axis
- LOAD on the center G3000 display now sorta shows torque/collective power and no longer follows engine throttle
- Thanks to @FireRx, @mnpostema & @Erik1520y’all have got some new turbine engine sounds
- Disabled annoying sounds from airplane logic (spin around in a circle to notice)
- Lights updated by @JD3 (ChrisPiAviation)
- Load factor reduced so you now can have crashes. Be careful with the pre-flight cinematics if you use the advanced flight model. Use developer mode to disable crash detection if you have problems.
- Enhanced feel of landings
- Weather/Terrain settings added back
- Color changes now for the flight model in use
- ENG stop/start buttons on center display
- GEN1/2 indication/buttons on the center display
- Added ground power support with toggle available on center display
- Fixed ground power button state
- Added parking brake indication and toggle on center display (helpful for users of virtual airlines, VATSIM, etc)
- Lights panel added to pilot’s G3000 display
- Contact points tweaked
- Repack 75 blackscreen fix
- Tweaked EIS
- Single engine support
- Battery capacity to spec
- Generator capacity to spec
- Engine goes to 100% rpm now
- Multiple interior lighting improvements
- Translational guidance indication (green dot) on HSI… centered is zero lateral/forward translation… automatically shows up when at very low speeds at any altitude
- Engine power now scales to collective in failures
- Density altitude now drives collective as you ascend
- PITOT HEAT toggle added on pilot’s G3000 display
- Users wanting to map FADEC on their input hardware can map the toggle to variometer - don’t use the set binding option, only the toggle one
