Airbus H135 v0.90 is now up on Flightsim.to! Leave us a 5 star review!
- COPILOT IS BACK! Ben may be toggled on or off by clicking the seatbelt straps
- PILOT model is also available by clicking on the CAPT’s seat buckle
- EICAS messages “light up” when appearing, and the ACK button dismisses them
- Add warnings tests: LAMPS, FIRE 1 and FIRE 2
- Add a rear overhead view, add GEN 1, GEN 2 and EPU switches to rear overhead
- Add fuel prime pumps (to be used during startup only)
- New (WIP) overhead panel and textures
- Add many new EICAS messages (Battery, Starter, IDLE, FUEL PRIME, GEN DISCONNECTED, MFD/Avionics overheat)
- Add ROTOR BRAKE (engages Parking Brake, does not currently slow down rotor)
- Parking brake removed from Config page
- Flight model: Tweak yaw acceleration for smoother takeoff in Advanced mode
- Flight Model: Boost ETL
- Flight Model: Ground effect is now relative to density altitude
- Update normal procedures on offline EFB
- Change BEACON to ACOL light
- Change NAV to POS light
- CONFIG: You may now remove the middle row of seats on the table Config page
- CONFIG: Add Visible EPU toggle to hide EPU model when inapplicable
- Fix collective texture (partially anyway)
- Fix carpet/map overlap on CAPTs side
- Fix FO’s cyclic stand bracket being missing
- Make the “internal Ariel ;)” spin sideways
- Remove taxi light (not realistic)
- Removed unused buttons on the main MFDs
- Add NR HI mode for increased performance (rotor RPM will not show greater than 100% yet)
- VMS engine instruments won’t go Orange/XX anymore
- Rear tablet is now toggled by clicking directly below where it appears (the console between the seats)
- Rear doors now have clickspots (just above the doors)
- Emergency lights switch added
- Ready For Takeoff config option will now set barometric pressure to the local setting.
- Edit camera pilot view position (better for VR)
- Add thumbnail.jpg for content manager
