I’m trying to assign axes I have on my flight simulator rig to cowl flaps and carb heat/alternate air but does not seem to be supported by the sim. Does anyone know of a solution to do this?
I’m using vjoy and Authentikit to control trim using my Honeycomb Bravo trim wheel - can something similar be achieved to do the cowl flaps and carb heat/alternate air?
I don’t use FSUIPC quite long time,
but from my last times it provided this capability. Check for sure that prior buy. I had on my Seneca extra joystick for cowl flaps defined. In sim they are not vissible but Simconnect or other available access can access them.
Yeah, I am sure there are ways to do this either through FSUIPC, Spad.Next or Axes&Ohs if you care to investigate those options. In the long run, you will probably like a transition to something like Spad, Axes or FSUIPC as it opens up a lot of flexibility.