Hello, I turned on frame gen and all the aircraft displays are very blurry. I have a 4070 super and a 7800x3D.
(ignore the TLOD)
Screenshot your settings.
That’s most likely due to DLSS. The only current way to get them sharp is TAA instead of DLSS
I gave up trying DLSS. If you fly airliners with glass cockpits, DLSS isn’t your friend.
2 Likes
Use taa instead of dlss. With your setup, you dont need it.
I had the same problem once, there is any easy get-around which I’ve been using for ages I just haven’t shared it. I personally don’t use DLSS but if you are on a lower-end pc and you need to few extra frames here’s how to get the most out of it.
- Set your NVIDIA DLSS super resolution to performance - this will make the screens show no motion blur when moving.
- Go into your userconfig file and look for secondary scaling, if you have lossless scaling from steam, which is what I have, set it to 2.2, otherwise you can put it 2.2-2.5 - basically the higher you go the more frames you are going to loose and I use the scaling feature on lossless scaling to make the screens look slightly sharper because I want the maximum FPS.
3 (Lossess scaling only)) Set up your scaling to LS1 and set the sharpness to around 2 - if you go too low the screens look to blurry, and too high they start to look greesy for some reason.
I hope this helps, and happy flying!