As soon as the tug attaches my plane’s main and nose gear wheels disappear into the tarmac so only the top 20% shows. Using GSX Pro and any commercial
Airliner. After engine start and tug disconnect all goes back to normal. Anyone else seen this?
I haven’t noticed that on my setup. Out of curiosity, what scenery/airplane are you using? See if others can replicate the issue.
KIAD by Flightbeam on ORBX. CS777. I must say, GSX Pro has always been wonky on my rig (13900K, 4090, DDR5). I’m continuously having to restart it and once pushback is started the only menu choices are “abort” and “stop”. No left or right.
I own neither of these add-ons, but I did a little research and came across a possible solution from the GSX forum. Seems the contact points on the CS777 are off, and you can adjust it by editing a value. I’ve copied the thread here:
this happens. I don’t notice using the 737 but i have it fully updated which otherwise eliminated this issue for most planes that i use.
I notice it more watching people on vatsim pushback using GSX. They do full wheelies and nose endos it’s hilarious
Is there a plane profile for the CS777 and do you have it installed?
I’ll check all of your suggestions. Thank you for your help!