I usually do similar to the above post, but a little more manual flying.
From memory since I’m not in front of sim:
- Turn on FD and set top altitude (whether cruise altitude or whatever ATC gives).
- While holding short runway, single notch of flaps and trim to bottom of green indicator.
- Line up on runway, hit TOGA.
- Set throttle to TO Detent (since you are using WT mods) and takeoff.
- Once airborne, gear up, raise flaps at V2+20. Pull throttle back to Climb Detent as soon as flaps are raised.
- Once past runway, set AP to NAV/FMS mode (unless following headings from ATC, then wait on this until they set you direct to waypoint). I do not turn on AP yet.
- Follow FD manually, trim to TOGA pitch.
- Turn on FLC, set speed to 240 (will see FD decrease pitch)
- Retrim to match FD.
- Once speed is matched to 240, engage autopilot.
- Switch from IAS to Mach at cross over point for M0.64 (close to FL300 I believe)