This solves is for me, thank you so much!!!
2 Likes
Thenak you guys! Disabling āinput repetitionā for avionics BUS1/2 switches FIXED the problem! Thanks for the whole effort you guys put in!
2 Likes
It worked, disabling āinput repetitionā for all avionics bus bindings helped me resolve the problem
Thanks for the solution
1 Like
Sadly disabling āInput Repetitionā did not work for me. My heading selecting binding was working fine, then suddenly it started only moving in 10 degree increments.
I disabled the input repetition, rebound the keys, bound them back, made sure it was still disableā¦ no luck. The bug is still present.
Any help would be appreciated for a work around until they fix the bug.
Hi
JudicatorDeath
I though I had the same issue, but diving a little further, it seems I missed a few avionics switches to disable repeat input.
I hope it helps to recheck all of them.
This solution fixed the issue for me. Now I can use my alpha avionics switches with the Cessna 172 cargo variant. It also works with the Grand Caravan (cargo). I havenāt tried other variants though.
Thanks to all for troubleshooting this one.
1 Like
As of 8/6/2025, Iām not seeing this issue, maybe they have resolved it. Either way, I turned off kep repetition. I have seen it create more problems than this setting is worth, especially on toggle switches.
I can unfortunately confirm this still exists, just had to do the whole turning off input repetition to get the heading dial to stop moving in 10 degree increments.
I struggled with this 10 degree heading bug movement issue until today.
Reading the posts here, I note that using the default control profile or removing input repetition fixed the issue. So, the issue is related to what event is assigned to the buttons for avionics master.
However, I discovered that if you use [electrical bus n to avionics bus n decrease / increase] (n = the bus number 1 or 2) and ensure input repetition is off then the heading increments normally.
I do not have Honeycomb yoke, only the Bravo Throttle Quadrant. I still have the same problem, but only C172. Heading bug/altitude bug steps 10 times. (10 degree / 1000 ft instead of 1 degree / 100 ft)
I dont think that ONLY the two Honeycomb product can cause the problem if you use it parallel. I donāt know what i can do fix the bug.
I still have this issue from time to time using an Axair MIAP with the basic C172. Iāve made no config changes - it just comes and goes. I just deal with it by changing the heading with the indicatorās onscreen knob and a mouse until it switches back.
I am having this problem in the A2A commanche and I donāt have any Honeycomb hardware.
I use a Logitech hotas.
I havenāt seen it anywhere else yet. I will check the 172 though.