AI traffic not leaving runways, forcing go arounds and ATC clutter

I’ve encountered a few times now when approaching large/busy airports that AI traffic often just sits idle after landing. This causes a massive clutter on the ATC channel with every 10 seconds saying “Idle airplane exit next taxiway” “Idle airplane exit runway when able” over and over and over and over again.

But the most annoying part is, when I arrive with the A320 after following the flightplan perfectly, I am told to go around because of this. If I decide to ignore that and land regardless, the landing isn’t logged in the logbook.

Is there a way to remove all AI traffic during flying in case there’s a plane stuck?

Hi @MrRobville,
There is a wish list on this that you can up vote.

You can also turn OFF AI Traffic in MSFS options.

Closing this topic as a duplicate - up vote the one in wish list.

2 Likes