ISSUE DESCRIPTION
Description of the issue: When in the ATR such as ~ATR 72-600 when I input a star in my case FAOR’s VASU3A Departure for runway 03L the ATR seemingly rounds up the waypoint JSV5.5 to JSV 6 which is half a mile further then JSV5.5. this causes the whole departure to become Miss aligned. Below I will attach 1, a picture from the G1000 showing the correct departure using GSV 5.5 then 2, a picture from the ATR showing how rounding up to JSV 6 completely messes up the departure and makes it unusable. This issue seems specific to the ATR, I have not had the same issue with any other aircraft.
FREQUENCY OF ISSUE
How often does this occur for you: Every time flying the VASU3A departure for 03L at FAOR.
REPRODUCTION STEPS
Please list clear steps you took in order to help our test team reproduce the same issue:
-
Load into a aircraft using another avionics system eg G1000 at FAOR and load in the VASUR3A departure, take note that it correctly uses JSV 5.5 and the left 90 degree turn after take off. (See image 1)
-
Then load into the ATR at FAOR and input the VASUR3A departure for runway 03L, notice how the departure now incorrectly uses JSV 6 (likely rounding up JSV 5.5). Also notice how instead of a 90 degree turn to the left the turn is now actually back tracking slightly due to the offset. (See image 2)
YOUR SETTINGS
[PC Only] Are you using Developer Mode or have you made any changes to it?
I am, however I just use it for a quick way to get to my community folder
[PC, MSFS 2020 Only] Are you using DX11 or DX12?
DX11
[PC Only] What GPU (Graphics Card) do you use?
GTX 1050TI
[PC Only] What other relevant PC specs can you share?
Ram:18Gb CPU: I7-6700
MEDIA
1)
