If I set the left knob to select “CRS”, the right knob rotates the VOR 1 needle in the OBS.
However, if I select VOR 2 in the CDI, turning the right “increase/decrease” knob generates no response; it does not move the VOR 2 needle around the OBS.
How can I configure the OBS for VOR 2 to work the way VOR 1 does??
You can’t unless you sacrifice one of the other functions of the left knob
I’ve sacrificed altitude and adjust that using the yoke
So my left knob is now assigned from the top as
IAS
Vs
Heading
Obs1
Obs2
Thanks. I’ll let you know if someone has a better solution.
I like this idea. I am going to order a Bravo, but this will give me errrrr… three autopilots. 1. Logitech, 2 Streamdeck and 3 Bravo. The idea of using the Bravo to drive OBS 2 is a cracker. Thank you very much.
You can do as follows after you switch CDI to VOR 2.
Create a unique switch binding in the settings for the Bravo for:
VOR (list in settings of the simulator) - Decrease VOR2 OBS & Increase VOR2 OBS by setting up a combination of two switches on your Bravo throttle quadrant, e.g. most two right switches (button 44 and button 46) plus the right rotator knob (joystick button 13 for increase and joystick button 14 for decrease). You can do this by rotating the rotator knob (right switch) to the left and right while the button switches are “active”.
Hi all:
It is much easier. Select “Decrease VOR2 OBS” and assing it button 14; select Increase VOR2 OBS" and assignt it button 13. That all and it works provided CDI 2 is active.
