Can't bind auto reverse on a tbm 930

User Support Hub Hardware & Peripherals
, , ,
1

I have a VKB stecs standard, and I can’t seem to bind any switch or lever to reverse thrust.
I have read and done all recommended procedures however, nothing works.
Any help would be appreciated. I am also awaiting a response from VKB.
Thanks
Gary

2

Which specific bindings have you tried?

3

The TBM 930 throttle is a nuisance all of its own, due to its design.

I remember that I had to set up controls using a mixture of insim and SPAD configurations to work them more or less as they are. Cant remember the reversers though.

Its even worse in MSFS2024.

4

Put mouse cursor over Throttle
Left click + right click
This grab the throttle
Then maintaining both buttons move throttle to Reverse position

5

Thanks for your time folks, I fixed the problem, I determined that; when I configured throttle the thrust travel was not going the full length of its travel. It was stopping at about 60%. I then, configured the throttle using the second method, using buttons VKB recommended. Finally the 2 triggers or pull levers in front of the throttle work. I use the hold reverse throttle instead of toggle on/off.
I wish to Thank You all for your interest and help.
Gary