When flying using my CH Products flightsim yoke, when switching to autopilot, the plane pulls hard left into a death spiral (using the a320 as it’s my current preferred craft) - checked my configuration in FS2020 and it all looks good, same in the control software providec by CH products. Anyone find a solution for this behavior? I see a few chats under the CH products tag that seem similar but not exactly what I am experiencing
Think I figured this out, reading through the other CH products posts (most about having to manually setup a profile, which I did NOT have to do - it WAS detected and profiled on it’s own) there were folks who had to set control surfaces to -50 sensitivity, this seems to have solved my issue, may tweak it some more for better elevator action - as currrently that’s TOO insensitive now, but think I am getting there