CH Pro Pedals Rudder Pedals

[LachsWaerter685]

Hello community

Since FS 95 via FSX, Prepar3d, X-Plane and then MSFS 2020 I have been using Ch Pro Pedals as rudder and wheel brakes. Everything is OK.
In MSFS 2024 I can adjust the brakes (X-axis and Y-axis), but it has no effect. Reverse (to try) cannot be adjusted.
Does anyone have a solution?

Many thanks
Ralph

[TheSevenflyer]

What command do you have them bound to?

[LachsWaerter685]

The brakes do not work on any aircraft.
The rudder works on all aircraft.

[FrankO7109]

Hi Ralph, that doesn’t look right to me. You have assigned digital controls ((ment for push buttons) to joystick axis. You’ll have to find axis controls for the brakes like right brake axis and left brake axis (no idea what that is in German, perhaps linke Bremsachse or similar, I have set my FS to English because of the terrible translations).

HTH
Frank

[LachsWaerter685]

Hello Frank
I clicked in the field to the right of “LEFT BRAKE” (below “search for input”) and then operated the left brake.
Then “x-axis” appeared.
The right brake also appears, then it is “y-axis”.
The rudder is the z-axis, which works.
The same thing is also stated in MSFS 2020…

But you’re right, it says digital, and where is the brake analog? I can’t find anything.

[LachsWaerter685]

Thank you very much, dear Frank

Your approach was right. I have now found the place where I can set it…
I was always looking for “BREMSE”, “BREMS” would have been better

Thank you, thank you, thank you