I received earlier, an addon relating to “texture” for this A32NX aircraft. This installed automatically and since then the simulation has been blocked completely. Only the aircraft’s control surfaces react to the joystick. It is not possible to activate any buttons or controls such as the push levers. I thought it could be from a conflict with my only Air France livery and installed it. The problem remains the same. I reinstalled the livery and started again four times, without success. The simulation does not work more This is the “development”: ac6847b.
It would probably be helpful if you’d post a link to whatever you installed. In any case, that are the typical symptoms of a mod incompatibility.
I haven’t installed anything. I just flew with a few other planes outside of FBW, especially B747 and Dreamliner, everything is ok. I come back to A32 NX, no button no key reacted, the power levers are inert. This has been happening since installing the ac6847b development version of FBW. I insist in saying that all the other devices work and react well. It is mind boggling.
What did you mean by this then?
Liveries can break aircraft. If you have installed a livery for the A32NX, that’s the most likely culprit.
What I downloaded from FlyByWire, is a usual addon as it sends it regularly which install automatically. As for the name, it mentioned “texture”, but nothing to do with liveries that besides it does not provide. Also, as I said, the only livery I put in “community” is the one for A32NX from flightsim.to. And I did the test of use it and take it off. It didn’t change anything. When you move the mouse over the buttons, no reaction and I affirm that with the other MSFS planes outside FBW, everything is correct and normal; i have used them.
To properly isolate the cause here, move everything out of your community folder, delete the fbw mod and reinstall the same version you’ve been testing using the installer and load up the sim with only that installed (no other community content at all).
If it works, one of your other mods/liveries is affecting it, and if it still exhibits the problems you mention, then that will narrow down the issue to something you can report to the flybywire team.
Heard, thank you
I am downloading the new development version! 1f36e0b, it is not the same as yesterday, which was: ac6847b.
Everything works fine with the downloaded “full module” development version. I tested the module with and without the Air France livery, everything works. I guess there must be a problem with the “development ac6847b” version. Are there other people on the forum who have downloaded this version?
As far as I can see, ac6847b had only one change from the previous version:
feat: chrono auto brightness by sidnov · Pull Request #5018 · flybywiresim/a32nx
Passed QA without an issue. There are also no specific mentions of ac6847b on the discord.
Maybe with you nothing happened, but on my computer, the simulation was very disturbed; no button on the cockpit pakfinnier and in the other screens worked. As I had nothing in the community, it was easy for me to control these absences. I uninstalled this version of FBW and replaced it with the new one and everything is back to normal.
Perhaps this is due to the materials you have in your computer (motherboard, graphics card, … or others).
What I do know is that this version "ac6847b is real and harmful to me.
I will add that I note the numbers of the different versions installed for a month and a half.