Cyclic Training Out of control flight

Hi,

Working my way through the initial helicopter training and all fine until I get to the cyclic training. I can hover no probs up to now and in free flight. At the point the trainer says he will let go and you need to account for rotor drfit, the helicopter goes completely out of control! Its really frustrating. Not sure its a control config issue as I can hover no probs in free flight and all the other training apart from this section? I’m using a Velocityone Flight stick on PC.

Thanks
Hugh

1 Like

Hi @Shuggy74 ,

Thank you for your post! Your topic has been moved to a sub-category of the User Support Hub

The General Discussion category is meant for discussions that fall outside of our other sub-categories.

If you would like other users to help you with an issue you are experiencing in the sim, consider these User Support Hub categories for your future post:

Aircraft & Systems
ATC, Traffic & NAVAIDs
Crashes (CTDs)
Hardware & Peripherals
Install, Performance & Graphics
Scenery & Airports
User Interface & Activities
Virtual Reality (VR)
Weather & Live Weather
Miscellaneous

Had exactly the same issue.

Tried the same helicopter that’s in the lesson in free flight and it’s perfectly flyable.

I ended up ignoring that lesson and just doing the others.

Still managed to pass the commercial rotorcraft license, well when I say passed, the eaxminer told me I’d passed but then I couldn’t shut the engine down, no matter what I did, so had to abort the test. Got to do it again, now but that’s a whole other bug!