ISSUE DESCRIPTION
Description of the issue:
When you Duplicate and Create a New Device Profile then Clear it out this will not survive the next plane loaded into.
In 2024 we could have and leave Blank Profiles so that using outside device control via SDK was not conflicting with Sim Bindings.
[PC Only] Did you remove all your community mods/add-ons? If yes, are you still experiencing the issue?
This has nothing to do with the community folder … This is the General UI deciding that it will not allow a profile to be empty…
FREQUENCY OF ISSUE
How often does this occur for you (Example: Just once, every time on sim load, intermittently)?
Every Single Time you load into a plane after clearing the Bindings and then going to another plane. The Profile you made will revert back to the default profile.
You MUST have at least 1 Event In that profile for it to NOT revert back to the defaults.
REPRODUCTION STEPS
1- Duplicate a Device General or Airplane Profile.
2- Give it a new Name (Assign it to All Aircraft and Default or don’t… done here or later via settings cog next to the profile selector will have the same results)
3- Click on the Settings COG – Click Clear – Click Apply to All Aircraft and Click set as default.
4- After Save and Back … Go back to Settings - Controller - Filter to Assigned – you will see that nothing is assigned.
5- Now you can switch back to the default profile… and Back to your New Blank Profile and all of the Defaults will be back in the blank profile.
5B – Don’t do the above SAVE and BACK. End Flight load into another plane and fly now. Go into the Settings - Controls and you will see that all the defaults have been applied again.
The only thing that will keep it from Reverting is to AT LEAST keep 1 thing in the Aircraft or General Profiles that you have created. Blank Profiles will Revert back to Default on next load.
YOUR SETTINGS
What peripherals are currently plugged in? Please name all of them as there could be a potential conflict.
TCA Pilot / TCA Airbus Throttle / WingWing FCU / TM TPM Peddals.
No there is no way for this to conflict – this is about creating empty profiles and it NOT keeping it Blank.
[PC Only] Are you using Developer Mode or have you made any changes to it?
Happens in both Dev or Non Dev Modes
[PC Only] What GPU (Graphics Card) do you use?
3090 – how would this affect the UI resetting bindings?
[PC Only] What other relevant PC specs can you share?
3970X threadripper and 64GB Memory NVMe drive … how would this have any impact on retaining Settings?
MEDIA
If I don’t leave at least 1 thing in General or Airplanes for this device it will revert all default bindings back for each of these categories.
[END OF FIRST USER REPORT]
For anyone who wants to contribute on this issue, Click on the button below to use this template:
Do you have the same issue if you follow the OP’s steps to reproduce it?
•
Provide extra information to complete the original description of the issue:
•
If relevant, provide additional screenshots/video:
•