ISSUE DESCRIPTION
Description of the issue: When flying a hold in the G3000, when you click “Cancel hold at XXX”,
the hold is immediately removed and the next leg is activated and the plane tries to fly this next leg, no matter where you were in the hold.
Expected behaviour, according to the G3000 manual: With exit hold armed, the aircraft will only exit the hold after passing the hold point. It will not immediately leave the hold.
From the real life G3000 manual: “The holding pattern will be exited at the hold waypoint. To cancel the request, touch the Cancel Button.”
FREQUENCY OF ISSUE
Every time, in all aircraft using the G3000.
REPRODUCTION STEPS
Please list clear steps you took in order to help our test team reproduce the same issue:
-
Create a flightplan
-
Enter a hold over any waypoint in the flightplan
-
when in the hold, click “exit hold” and then “cancel the hold at ‘waypoint’”.
-
Note that the hold is removed, and the plane tries to fly the next leg.
YOUR SETTINGS
If the issue still occurs with no mods and add-ons, please continue to report your issue. If not, please move this post to the User Support Hub.
What peripherals are you using, if relevant: not relevant
[PC Only] Are you using Developer Mode or have you made any changes to it? No
[PC, MSFS 2020 Only] Are you using DX11 or DX12?
[PC Only] What GPU (Graphics Card) do you use? not relevant
[PC Only] What other relevant PC specs can you share? not relevant
