Honeycomb bravo quadrant, switches not detected in MSFS when start scanning activated?

For some reason when i goto search and try to flip a switch to detect it and it does the start scanning, the switches on the bravo arent detected (yet i think a few actually do something)… other buttons like the selector dial or the AP are detected just fine.

Any idea what is going on here? Only thing i can think of is that i installed the Knobster plugin, knobfs, but i also tried disconnecting that one.

Thanks in advance

Do you clixk the switch and then clocknit back to it’s start position. Only registers when you click on then off.