How to move dead zone for throttle axis to start of curve?

User Support Hub Hardware & Peripherals
1

Hi,
The deadzone for all axes all appear to be in the center is there a way to move it to the start of the curve?
I have a Virpil throttle setup with an idle detent for DCS. In DCS you can change the axis type to slider, so that the deadzone is at the beginning of the curve, is there a way to do that in MSFS?

I want to zero out the first 5% or so, but in MSFS the deadzone is in the middle, which is fine for joysticks, but doesn’t work for throttle. The extremity slider also doesn’t work for me here either as it cuts off the top of the curve too.

I’ve tried messing around with all the sliders to see if I can get what I need but haven’t had much luck.

2

There should be an Extreme Deadzone slider.. But I’m not sure if that would help you or not.

3

Same problem with the dead zone for brakes on the rudder pedals. Impossible to have the dead zone at the beginning of the curve if the axis is not centered.

@FerFoxAche5116 You can use it with FSUIPC but you have to buy it to unlock the options. Or maybe you can to it within the driver setting of the controller?