Since this is a “how to” question, rather than an error report, I hope it is OK if I get straight to the question.
I have adopted the new process (lock?) where controls are highlighted when the mouse hovers over them. However, whereas previously, in the Daher 930, for example, I could “press” the bearing button - left click - (to set the current bearing) rather than scroll either side of it (which otherwise adjusts the bearing) I don’t know how to do this, post SU5.
The same applies to other controls, such as the chart zooming dial on the Garmin 3000.
I should be most grateful for any advice on this.
Thank you!
Left click to lock, right click to press. It should show exactly that in the popup tooltips unless you have disabled them. 
Note that you may need to reset your mouse control bindings to the new defaults in the Options → Controls screen if you haven’t done so.
Thank you for your quick reply.
I have indeed turned off the tool tips because they were covering the buttons! Unfortunately, I believe that I do need to re-set the menu items. Help here would be really appreciated, as I am not sure which ones to set.
I did set the primary ones, thanks to another forum member, which gave me control over the left mouse button, but that was all.
Thanks again!
1 Like