In MSFS 2024, I capture the ILS signal during landing, but the aircraft subsequently starts applying throttle and climbing on its own. It then switched to V/S 1000 mode.Even though I had made all the preparations for landing, a mistake like this really spoils the mood. Does anyone have any suggestions for a solution?
Does it happen at every airport you fly to? Does it happen in different aircraft? I flew an ILS last night with no issue. Was it a 3rd party airport you were flying the approach into?
It happens at every airport. The flight goes smoothly right up to the landing phase. Then, I capture the glideslope and localizer, and the aircraft begins to descend gradually. However, for some reason I can’t identify, it suddenly applies thrust and starts climbing again.
With all airplanes?
Flybywire A320
sounds like alpha floor / toga Lk
it would help if you posted a screen capture of your flight displays while it is happening
i remember the same thing used to happen to me with the inibuilds a320… while nicely on the glideslope, everything configured properly… the alpha floor was triggered for some reason i could never quite explain
hasn’t happened to me for a while now
What is your CDI set to?
I set a large dead zone for the “climb” setting during throttle calibration on the Flybywire tablet. That solved my problem. Thanks, everyone.
This is already related specifically to the plane from your author, but I think they can help you here.