After coming out of paused flight while flying Inibuilds A320neo v2 aircraft - engine 1 immediately shuts down - everfy time. I exit pause via the “SET PAUSE OFF” command mapped to my PC keyboard’s CTRL + P keystroke.
To restart the engine, I follow the directives on the cockpit display - THR LEVER 1 IDLE - if no relight after 30S - ENG MASTER 1 OFF and ENG 1 SHUTDOWN .
The Engine only restarts if I also START the APU and enable the APU Bleed.
- Need a fix to prevent ENG 1 Shutdown when coming out of PAUSE.
- Need clarification as to whether APU is required to relight engine in flight after unexpected shutdown
Does it happen if you do it from the pull down menu? If it doesn’t sounds like you have two controls bound to the same key on your joystick.
The pull down menu does an “active pause” which is different from “set pause on” and "set pause off’. I checked my active keyboard profile for all mapped sequences - did not see one there. I will try mapping the set pause off to a different key combination to see if there is some other conflict with that key combination of CTRL P
I just remapped it to RIGHT-CTRL P - and it shut down engine one again.
I also tried with ALT-P. If I hit ALT-P with the engines running and NOT PAUSED - it does not shut down the engine. It only happens after I have engaged via a key combination that issues SET PAUSE ON - followed by SET PAUSE OFF.
I’ll give it a go tomorrow and map those to the same keys.
I just recreated this issue with Active Pause also. So to quickly restart Engine 1 - turn on IGN, then turn off ENG 2 BLEED and ENG1 will restart. After ENG1 is AVAIL - turn ENG 2 BLEED back on.
I’ve tried to replicate it but on my machine it doesn’t shut down engine 1. I’m wondering if there is another mapping somewhere causing an issue but why it should happen coming out of active pause I dont know, unless that binding it also shutting down the engine. Have you looked at the fuel cut offs and see if its mapped to the same key combination?
The fuel cutoff switches do not move when this happens. I will probably have to go into spad.next monitor to detect the trigger. My next test will be without my honeycomb alpha and bravo enabled, and without spad.next.
Flying Airbus 320 V2 When I ESC from the sim for a few minutes and then return to flight I get an unflyable aircraft due to failures in hydraulics and electrical systems. I have posted this issue before but do not get any response.
for me when i entering the efb, engine master switches off.
